Ricoh MP 402SPF Service Manual

4.Appendices: Software Configuration
175
4. Appendices: Software Configuration
Printing Features
Behavior of USB Printer Detection
An MFP/LP connected via USB sends its product name and unique serial number. With the data, the machine
determines whether requires a printer driver for the USB device to be installed.
SP5-844-005 allows you to change how to determine the MFP/LP requires a printer driver installation:
 OFF
If SP5-844-005 is set to OFF, the unique serial number of the device is sent to the computer. As a result, if the
device is swapped out for a device of the same product, pop-up messages will appear, because the serial
numbers between the two are different.
 Level 1
If SP5-844-005 is set to Level 1, a common serial number for the product such as "MP 305+" series is sent to the
computer. As a result, if the device is swapped out for a device of the same product, pop-up messages will not
appear because the devices are recognized as having the same serial number.
 Level 2
If SP5-844-005 is set to Level 2, a common serial number for all GW/GW+ models is sent to the computer. As a
result, if a GW/GW+ device is swapped out for a different GW/GW+ device, pop-up messages will not appear
because the devices are both recognized as being based on GW/GW+.
Auto PDL Detection Function
Overview
The Auto PDL Detection function gives the MFP the ability to determine the PDL of a job or of specific parts of a job. This
can be especially useful in cases where the PDL is not specified or if the job contains multiple PDLs. This is only possible
if the job was not created using a driver.
Conditions for detection of the PDL
The MFP will only attempt to detect a job's PDL if all of the following conditions are met.
 No @PJL ENTER LANGUAGE command is contained in the job
 No submission protocol options (lpr, ftp, rcp, or rsh options) have been used to specify the PDL
 User Tools > Printer > System > Printer Language = Auto
 The printer is unable to detect PCL6 or RPCS. However these are almost always created using a driver and
therefore contain the PJL command specifying the PDL.

Ricoh MP 402SPF Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Maximum Print Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Scan Resolution	600 x 600 dpi
Fax Capability	Yes
Maximum Paper Size	A4
Warm-up Time	21 seconds
Memory (RAM)	2 GB
Fax Transmission Speed	33.6 Kbps
Copy Resolution	600 x 600 dpi
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB, Ethernet, Wi-Fi
Control Panel	Touchscreen
Mobile Printing	Yes
Hard Disk Drive	320 GB (Optional)
Network Connectivity	Ethernet
Print Speed	Up to 42 ppm (Letter)
Copy Speed	Up to 42 cpm (Letter)