Ricoh MP 402SPF Service Manual

2.Mechanism
31
Controlling the Power Supply
Exiting Energy Saving Modes
Because this model of Smart Operation Panel has no hardware keys, the MFP exits from energy saving mode when the
user does one of the following:
 Touches the display panel
 Lifts the ADF
 Sets an original in the ADF
Screen Startup Mode
Startup Modes
There are two screen startup modes. The factory default setting is Normal.
1. Normal
This is the standard startup mode. When the main power of the MFP is turned ON, the control panel starts up using
less power compared to Quick mode.
2. Quick
By preparing for the next startup when the machine shuts down, the control panel starts up faster than in Normal
mode.
Changing the Screen Startup Mode
Screen Startup Mode can be changed in Screen Features.
Select [Screen Features] > [SYSTEM] > [Screen Device Settings] > [Screen Startup Mode], and then select [Normal] or
[Quick].
 In the following cases, the control panel starts up in Normal mode even if [Quick] is selected.
 The power cord has been disconnected from the power outlet after the last shutdown.
 The MFP is turned ON after being turned OFF due to reasons such as a power failure.
 The MFP was not properly shut down the last time it was turned OFF.

Ricoh MP 402SPF Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Maximum Print Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Scan Resolution	600 x 600 dpi
Fax Capability	Yes
Maximum Paper Size	A4
Warm-up Time	21 seconds
Memory (RAM)	2 GB
Fax Transmission Speed	33.6 Kbps
Copy Resolution	600 x 600 dpi
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB, Ethernet, Wi-Fi
Control Panel	Touchscreen
Mobile Printing	Yes
Hard Disk Drive	320 GB (Optional)
Network Connectivity	Ethernet
Print Speed	Up to 42 ppm (Letter)
Copy Speed	Up to 42 cpm (Letter)