To use the Z-fold function, you must set the Z-fold support tray. For details about how to set the Z-fold
support tray, see "When the Amount of Output Paper Is Less than the Stack Capacity", Troubleshooting
.
• You cannot use Punch with this function.
Original orientation and Z-fold position
Place all the originals in the ADF in the orientation in which they can be read normally. When
placing the original on the exposure glass, keep the same orientation, but place the original facing
downwards.
Original
orientation
Placing the original
on the exposure
glass
Placing the
original in the ADF
Direction of
fold
*1
Right fold
Bottom fold
*1
The above table shows Z-fold positions. The orientation of the paper does not indicate the orientation of
delivery.
Finishing
67
To Next Page
Loading...
