• IPDS Tray
•
LCT
Default: [Auto]
• Auto
• IPDS Tray
• Bypass Tray
Default: [Auto]
• Auto
• IPDS Tray
• If [IPDS Tray] is selected, enter the tray parameter replacement value for each paper tray,
using up to 254 digits.
Corner Staple Angle
Selects [Vertical] or [Slant] for the angle of stapling.
Default: [Vertical]
•
Vertical
Staples vertically.
• Slant
Staples diagonally.
Offset
Specifies whether or not the output is offset (jogged).
Default: [On]
• On
Output is offset (jogged) when requested by the job.
• Off
Output is never offset (jogged).
• This menu appears only when using the machine with finisher.
Default Punch Pattern
Specifies the default number of holes to punch if the punch unit provides a selection (for example,
two or four holes).
• [Tray Form] and [Tray Mapping] appear differently depending on the machine type.
3. Accessing User Tools
18
To Next Page
Loading...
