Ricoh MP 9003 Series User Manual

17. Check that [SMB] is selected.
18. Press [Change] or [Browse Network], and then specify the folder.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network.
19. Press [Connection Test] to check the path is set correctly.
20. Press [Exit].
If the connection test fails, check the settings, and then try again.
21. Press [OK].
22. Press [User Tools] (
) on the top right of the screen.
23. Press [Home] ( ) at the bottom of the screen in the center.
Locating the SMB folder manually
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
6. Scan
126

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet