Ricoh MP 9003 Series User Manual

Placing Originals
Placing Originals on the Exposure Glass
• Keep your hands away from the hinges and exposure glass when lowering the ADF. Not doing
so may result in an injury if your hands or fingers are pinched.
• Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.
1. Lift the ADF.
Be sure to lift the ADF by more than 30 degrees. Otherwise, the size of the original might not be
detected correctly.
2. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
Start with the first page to be scanned.
1
1
DPZ017
1. Positioning mark
3. Lower the ADF.
Placing Originals in the Auto Document Feeder
Be sure not to block the sensor or load the original untidily. Doing so may cause the machine to detect
the size of the original incorrectly or display a paper misfeed message. Also, be sure not to place
originals or other objects on the top cover. Doing so may cause a malfunction.
Placing Originals
69

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet