Ricoh MP 9003 Series User Manual

Loading Paper into Trays 2 and 3
In the following example procedure, paper is loaded into tray 2.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Check the paper edges are aligned at the right side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52–59 g/m
2
(14–15 lb. Bond), it may wrinkle.
1. Carefully pull out the paper tray until it stops.
CJW103
2. Square the paper and load it print side down.
Do not stack paper over the limit mark.
DQA154
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in trays 2–3 by adjusting the positions of side fences and
end fence. For details, see "Changing the Paper Size in Paper Trays", Paper Specifications and
Adding Paper.
9. Adding Paper and Toner
150

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet