EasyManuals Logo

Ricoh MP 9003 Series User Manual

Ricoh MP 9003 Series
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
When Other Messages Appear
Message Cause Solution
"Firmware update will start.
Press [OK]. It will start
automatically after 30
seconds have elapsed."
Automatic firmware update
is activated and it is time for
an automatic update.
If you want to start the firmware
update, press [OK], or let it start
automatically after 30 seconds.
If you do not want to start the
firmware update, press [Cancel]
before 30 seconds have elapsed.
Do not turn off the power switch
during the firmware update.
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" is
referred to as a "wireless
card".)
The wireless LAN
board was not inserted
when the machine was
turned on.
The wireless LAN
board was pulled out
after the machine was
turned on.
The settings are not updated
although the unit is detected.
Turn off the power, and then check the
wireless LAN board is inserted
correctly. After this, turn on the power
again. If the message appears again,
contact your service representative.
"Clean the scanning glass.
(Located next to the
exposure glass.)"
The scanning glass or
guide plate of the ADF
is dirty.
Clean the scanning glass or guide
plate. See "Maintaining Your
Machine", Maintenance and
Specifications.
"Following output tray is full.
Remove paper."
The output tray is full. Remove paper from the output tray to
resume printing. If paper is destined for
the finisher shift tray, to prevent paper
from falling off the tray press the [Stop]
to suspend printing, and then remove
the paper. Press [Continue] on the
display panel to resume printing.
When using the multi-folding unit, the
number of sheets per copy paper stack
differs depending on the paper type
and fold type.
10. Troubleshooting
232

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh MP 9003 Series and is the answer not in the manual?

Ricoh MP 9003 Series Specifications

General IconGeneral
Print Resolution1200 x 1200 dpi
Duplex PrintingStandard
Standard FeaturesPrint, Copy, Scan
Memory (RAM)2 GB
Hard Disk Drive320 GB
Copy Resolution600 x 600 dpi
Print Speed90 ppm
Paper Capacity8, 300 sheets maximum
Paper SizeA3, A4, A5, B4, B5
Paper Weight52 to 300 g/m²
Optional FeaturesFax, Additional Paper Trays, Finisher Options
Power SourceAC 220-240V, 50/60Hz
Scan Resolution600 x 600 dpi
Copy Speed90 ppm
Fax Resolution200 x 200 dpi
Network ConnectivityEthernet

Related product manuals