Ricoh MP 9003 Series User Manual

Problem Cause Solution
An error message is still
displayed, even if misfed
paper is removed.
Paper is still jammed in the
tray.
Remove the jammed paper by
following the procedures displayed on
the control panel. For details about
removing jammed paper, see
"Removing Jammed Paper",
Troubleshooting.
An error message is still
displayed, even if the
indicated cover is closed.
One or more of the covers
that are not indicated are
still open.
Close all the covers of the machine.
Images are printed on the
reverse side of the paper.
You may have loaded the
paper incorrectly.
Load the paper correctly. For details
about loading paper, see "Loading
Paper", Paper Specifications and
Adding Paper.
Misfeeds occur frequently. Using curled paper often
causes misfeeds, soiled
paper edges, or slipped
positions while performing
staple or stack printing.
• Take the stiffness out of the paper
with your hands to straighten out
the curl.
• Load the paper up side down so
that the curled edges face
downward. For details about
recommended paper, see
"Recommended Paper", Paper
Specifications and Adding Paper.
• Lay cut paper on a flat surface to
prevent paper from curling, and
do not lean it against the wall. For
details about the proper way to
store paper, see "Paper Storage",
Paper Specifications and Adding
Paper.
When You Have Problems Operating the Machine
181

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet