Ricoh MP 9003 Series User Manual

When other errors occur
Message Cause Solution
"85: Error" The specified graphics
library is unavailable.
Check that the data is valid.
"98: Error" The machine could not
access the hard disk
correctly.
Turn off the power, and then back on
again. If the message appears
frequently, contact your service
representative.
"99: Error" This data cannot be printed.
The specified data is either
corrupt or it cannot be
printed from a memory
storage device using the
Direct printing function.
Check that the data is valid. For details
about the kinds of data that can be
printed from a memory storage device
using the Direct printing function, see
"Direct Printing from a Memory
Storage Device", Print.
"Command Error" An RPCS command error
occurred.
Check using the following procedure:
• Check if the communication
between the computer and the
machine is working correctly.
• Check if the correct printer driver
is being used.
• Check if the machine's memory
size is set correctly in the printer
driver.
• Check that the printer driver is the
most up-to-date version available.
"Compressed Data Error." The printer detected corrupt
compressed data.
• Check the connection between
the computer and the printer.
• Check that the program you used
to compress the data is
functioning correctly.
10. Troubleshooting
212

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet