Ricoh MP 9003 Series User Manual

Message Cause Solution
"Exceeded maximum
number of file to store.
Delete all unnecessary files."
Too many files are waiting to
be sent.
Try again after they have been sent.
When the WSD scanner function cannot be used
Message Cause Solution
"Cannot communicate with
PC. Contact the
administrator."
WSD (Device) protocol or
WSD (Scanner) protocol is
disabled.
For details about how to enable or
disable the WSD protocol, see
"Enabling and Disabling Protocols",
Security Guide.
"Cannot start scanning
because communication was
failed."
Scan Profile is not set on the
client computer.
Set Scan Profile. For details about how
to do this, see "Creating a New Scan
Profile", Scan.
"Cannot start scanning
because communication was
failed."
The [Take no action] setting
has been selected on the
client computer, forcing the
client computer to remain
inactive when it receives
scan data.
Open scanner properties, click the
[Events] tab, and then select [Start this
program] as the computer's response
when it receives scan data. For details,
see your operating system's Help.
"Cannot start scanning.
Check the setting(s) on the
PC."
The Scan Profile might be
incorrectly configured.
Check the Scan Profile configuration.
Messages Displayed When You Use the Scanner Function
223

Ricoh MP 9003 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Standard Features	Print, Copy, Scan
Memory (RAM)	2 GB
Hard Disk Drive	320 GB
Copy Resolution	600 x 600 dpi
Print Speed	90 ppm
Paper Capacity	8, 300 sheets maximum
Paper Size	A3, A4, A5, B4, B5
Paper Weight	52 to 300 g/m²
Optional Features	Fax, Additional Paper Trays, Finisher Options
Power Source	AC 220-240V, 50/60Hz
Scan Resolution	600 x 600 dpi
Copy Speed	90 ppm
Fax Resolution	200 x 200 dpi
Network Connectivity	Ethernet