3. Make sure "Ready" appears on the screen.
4. Make sure [Immed. TX] is not highlighted.
5. Place the original into the ADF.
6. Make the scan settings such as scan size and resolution.
7. Configure the transmission settings such as [TX Mode] as necessary.
8. Specify a destination.
You can enter the destination's number or address directly or select from the Address Book by
pressing the destination key.
If you make a mistake, press [Clear], and then enter again.
9. When sending the same original to several destinations (broadcasting), specify the next
destination.
4. Fax
92
To Next Page
Loading...
