Using Utilities to Make Network Settings
This section describes how to make network settings using utilities.
You can also specify network settings using utilities such as Web Image Monitor, SmartDeviceMonitor for
Admin, and telnet.
• These settings should be made by the system administrator, or with the advice of the system
administrator.
• For details about using Web Image Monitor, see "Using Web Image Monitor".
• For details about using SmartDeviceMonitor for Admin, see "Using SmartDeviceMonitor for Admin".
• For details about using telnet, see "Using telnet".
• p.125 "Using Web Image Monitor"
• p.139 "Using SmartDeviceMonitor for Admin"
• p.164 "Remote Maintenance by telnet"
Interface Settings
This section describes how to make Interface settings using utilities.
Change settings by using Web Image Monitor, SmartDeviceMonitor for Admin, and telnet.
[Network] [Machine IPv4 Address] [Auto-Obtain (DHCP)]
• Web Image Monitor: Can be used for specifying the setting.
• SmartDeviceMonitor for Admin: Can be used for specifying the setting.
• telnet: Can be used for specifying the setting.
[Network] [Machine IPv4 Address] [Specify] "IPv4 Address"
• Web Image Monitor: Can be used for specifying the setting.
• SmartDeviceMonitor for Admin: Can be used for specifying the setting.
• telnet: Can be used for specifying the setting.
[Network] [Machine IPv4 Address] [Specify] "Subnet Mask"
• Web Image Monitor: Can be used for specifying the setting.
• SmartDeviceMonitor for Admin: Can be used for specifying the setting.
• telnet: Can be used for specifying the setting.
[Network] [IPv4 Gateway Address]
• Web Image Monitor: Can be used for specifying the setting.
Using Utilities to Make Network Settings
101
To Next Page
Loading...
Need help?
General
