Menu User Tool Setting Requirements
Interface Settings/Network Permit SNMPv3 Communication As required
Interface Settings/Network Permit SSL / TLS Communication As required
Interface Settings/Network Host Name As required
File Transfer SMTP Server Necessary
File Transfer SMTP Authentication As required
File Transfer POP before SMTP As required
File Transfer Reception Protocol As required
File Transfer POP3 / IMAP4 Settings As required
File Transfer Administrator's E-mail Address As required
File Transfer E-mail Communication Port As required
File Transfer
Program / Change / Delete E-
mail Message
As required
File Transfer Scanner Resend Interval Time As required
File Transfer Number of Scanner Resends As required
• For the Effective Protocol setting, check that the protocol you want to use is set to [Active].
• [LAN Type] is displayed when the wireless LAN interface board is installed. If both Ethernet and
wireless LAN are connected, the selected interface takes precedence.
• When POP before SMTP is set to [On], also make settings for Reception Protocol and POP3 / IMAP4
Settings.
• When setting POP before SMTP to [On], check POP3 port number in E-mail Communication Port.
• p.33 "Interface Settings"
• p.41 "File Transfer"
Wireless LAN
This section lists the settings required for sending e-mail with an Wireless LAN connection.
Network Settings Required to Use E-mail Function
83
To Next Page
Loading...
Need help?
General
