Changing the Network Interface Board Configuration
Follow the procedure below to change the network interface board configuration using
SmartDeviceMonitor for Admin.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
3. In the list, select a machine whose configuration you want to change.
4. On the [Tools] menu, click [NIB Setup Tool].
A Web browser opens and the window for entering the login user name and password for the Web
Image Monitor administrator appears.
NIB Setup Tool starts. Click [Web browser], and then click [OK].
5. Enter the login user name and password, and then click [Login].
For details about the login user name and password, consult your network administrator.
6. Configure settings using Web Image Monitor.
7. Click [Logout].
8. Quit Web Image Monitor.
9. Quit SmartDeviceMonitor for Admin.
• For details about login user names and passwords, see Security Reference, which is the administrator's
manual.
• For details about Web Image Monitor, see “Using Web Image Monitor”.
• p.125 "Using Web Image Monitor"
Using SmartDeviceMonitor for Admin
141
To Next Page
Loading...
Need help?
General
