Ricoh MP C2800 User Manual

Using NetWare
This section describes the setting procedure for network printers in the NetWare environment. In the
NetWare environment, you can connect the machine as a “print server” or “remote printer”.
• IPv6 cannot be used on this function.
Setting procedure
• When using the machine as a print server
1. Installing SmartDeviceMonitor for Admin
2. Setting the network interface board.
3. Turning the machine off and then back on.
• When using the machine as a remote printer
1. Installing SmartDeviceMonitor for Admin.
2. Setting the network interface board.
3. Setting NetWare.
4. Starting the print server.
• This procedure assumes an environment is already prepared for normal NetWare running
the printing service setting.
• The procedure is explained with the following example settings:
• File server's name ...CAREE
• Print server's name ...PSERV
• Printer's name ...R-PRN
• Queue name ...R-QUEUE
Using SmartDeviceMonitor for Admin
To use the machine in a NetWare environment, use SmartDeviceMonitor for Admin to set the NetWare
printing environment.
Printers listed by SmartDeviceMonitor for Admin
SmartDeviceMonitor for Admin lists printers connected to the network. If you cannot identify the
machine you want to configure, print configuration page, and then check the machine name.
• The NetWare Client provided by Novell is required to set the printing environment using
SmartDeviceMonitor for Admin under the following environments:
• NDS or Bindery mode in Windows 2000
3. Using a Printer Server
114
3

Ricoh MP C2800 Specifications

General

Print Technology	Laser
Print Speed	28 ppm
Max Print Resolution	600 x 600 dpi
Copier Speed	28 cpm
Copy Resolution	600 x 600 dpi
Reduction/Enlargement	25% - 400%
Fax Speed	33.6 kbps
Functions	Print, Copy, Scan, Fax
Automatic Duplexing	Yes
Hard Drive	80 GB
Scan Resolution	600 dpi
Connectivity	USB 2.0, Ethernet
Operating System Compatibility	Windows, Mac