POP before SMTP
Specify POP authentication (POP before SMTP).
When sending e-mail to an SMTP server, you can enhance the SMTP server security level by
connecting to the POP server for authentication.
The default setting is [Off].
If you set POP before SMTP to [On], specify the waiting time after authentication, user name, e-mail
address, and password.
• Wait Time after Authent.: “300” msec.
Specify [Wait Time after Authent.] from zero to 10,000 milliseconds, in increments of one
millisecond.
• User Name
Enter the user name using up to 191 characters. Spaces cannot be entered.
• E-mail Address
Enter the E-mail Address using up to 128 characters. Spaces cannot be entered.
• Password
Enter the password using up to 128 characters. Spaces cannot be entered.
To enable POP server authentication before sending e-mail via the SMTP server, set [POP before
SMTP] to [On]. E-mail is sent to the SMTP server after the time specified for [Wait Time after Authent.]
has elapsed.
If you select [On], enter server name in POP3/IMAP4 Settings. Also, check POP3 port number in E-
mail Communication Port.
Reception Protocol
Specify the Reception Protocol for receiving Internet Fax.
The default setting is [POP3].
POP3 / IMAP4 Settings
Specify the POP3 / IMAP4 server name for receiving Internet faxes.
The specified POP3 / IMAP4 server name is used for [POP before SMTP].
The default setting is [Auto].
• Server Name
If DNS is in use, enter the host name.
If DNS is not in use, enter the POP3 / IMAP4 or server IPv4 address.
Enter POP3 / IMAP4 server name using up to 127 characters. Spaces cannot be entered.
• Select Encryption as follows:
Encryption-[Auto]
Password encryption is automatically set according to the POP/IMAP server settings.
File Transfer
43
To Next Page
Loading...
Need help?
General
