64: [Adjust Disengage Timing of Ppr Trns]
Adjust the timing for the intermediate transfer belt and the paper transfer unit to separate during paper
contact/separation.
Use this to reduce the jitter
*1
produced during paper separation if it cannot be reduced sufficiently by
[Ppr Trns Contact and Disengage Mode]. Also, use this to reduce the image quality degradation during
the separation.
To adjust the separation timing, press [−] to make the paper separate before its trailing edge exits from
paper transfer roller, and press [+] to make it separate after its trailing edge exits from the paper transfer
roller.
Setting Items Max. Value Min. Value Step Unit
[Adjust Disengage Timing of Paper
Transfer]
5 -10 1 mm
*1
The jitter occurs when the leading or trailing edge of paper that passes through the paper transfer unit is
transmitted to the drum unit via the immediate transfer belt, causing banding.
65: [Textured Paper Mode]
Specify whether or not to enable Textured Paper mode.
If set to [On], the paper transfer voltage settings (66 – 73) are enabled.
Setting Items Values
[Textured Paper Mode] [On]
[Off]
66: [Txt Ppr: Ppr Trns Voltage: B&W: Side 1]
Adjust the paper transfer voltage applied to Side 1 when printing in black and white with Textured
Paper mode enabled.
Press [+] to increase the voltage and [−] to reduce it.
Setting Items Max. Value Min. Value Step Unit
[Txt Ppr: Paper Transfer Voltage: B&W:
Side 1]
14.0 0.0 0.1 KV
Setting Values
103
To Next Page
Loading...
