[Machine: Maintenance]
0301: [Execute Cleaning Initial Setting]
Initialize the cleaning unit for the PCU.
Perform this after replacing the drum unit or cleaning unit for the PCU. For details about replacing units,
see the Replacement Guide.
This operation takes one or two minutes. During this operation, a message appears on the control panel.
Do not pull out the drawer while the message is being displayed.
Setting Items Values
[All Colors] Press [OK].
[Cyan, Magenta, Yellow]
[Black]
[Cyan]
[Magenta]
[Yellow]
• Perform this only once every time you replace a unit. Do not perform it repeatedly.
0302: [Execute Process Initial Setting]
Initialize print settings at once.
Perform this after replacing the drum unit, cleaning unit for the PCU, charge roller unit, transfer unit, or
cleaning unit for intermediate transfer belt. For details about replacing units, see the Replacement Guide.
This operation takes one or two minutes. During this operation, a message appears on the control panel.
Do not pull out the drawer while the message is being displayed.
Setting Items Values
[All Colors] Press [OK].
0303: [ITB Manual Lubrication]
Lubricate the intermediate transfer belt.
Setting Values
35
To Next Page
Loading...
