Setting Items Max. Value Min. Value Step Unit
[Adjust Magnification of Side 2 With Feed
Dir]
0.500 -0.500 0.025 %
14: [Trailing Edge Full Bleed]
Specify whether or not to enable the mode to omit the margin at the trailing edge of the paper.
If set to [On], printing is performed without leaving a margin at the trailing edge of the paper. You can
reduce the chipping of images at the trailing edge of the paper when printing an image covering the
whole sheet.
Setting Items Values
[Trailing Edge Full Bleed] [On]
[Off]
Line Speed Adjustment
To prevent the paper becoming too tight or too slack during transfer, set all the line speed adjustment
settings for the paper transfer path to the same value. However, if adjustment of individual items is
necessary to correct image degradation, perform the adjustment according to the instructions in
Troubleshooting.
15: [Process Speed Setting]
Adjust the machine's copy/print speed.
Pro C5100S
• [High]
65 cpm (full speed)
• [Middle]
50 cpm
• [Low]
32 cpm
Pro C5110S
• [High]
80 cpm (full speed)
4. Details of Menu Items in Advanced Settings
86
To Next Page
Loading...
