Ricoh PRO C7200X - Page 116

1.SC Codes
112
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Thermopile disconnected or defective
 Thermistor disconnected or defective
 Reconnect or replace the Fusing Thermistor (Roller Shaft)
 Replace the fuser unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC579-
02
A
Sensor 8: Fusing Thermistor (Roller Shaft) disconnected 2
When temperatures lower than 50°C are detected continuously for 1055 seconds
or more, SC occurs. (Excluded time: 400 seconds are excluded.)
The monitoring cycle is 100 ms.
 Thermopile disconnected or defective
 Thermistor disconnected or defective
 Reconnect or replace the Fusing Thermistor (Roller Shaft)
 Replace the fuser unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC580-
01
D
Temperature Decrease Detection: Heating Roller Thermopile
Disconnection during paper feed
The thermopile detected -10 degrees less than target temperature after correction
continuously for 150 seconds or longer during or after paper feeding
Removal time: 50 seconds (excludes removal time)
 Replace the fusing lamp.
 Replace the Heating Roller Thermopile.
 Replace the Fuser Unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC581-
01
D
Secondary Power Cord Not Connected
The main power cord is connected but the secondary power cord is not
connected.
 The secondary power cord is not connected.
 Circuit breaker is off.
 Harness broken
 AC drive/IOB defective.
 Turn the machine off and plug in the secondary power cord again.
 Check that the circuit breaker is on. If off, turn it on.
 Replace the harness.
 Replace the AC drive/IOB.