Ricoh PRO C7200X - Page 326

1.SC Codes
322
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the TE press lever motor.
 Replace the TE press lever HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
20
B
Perfect Binder: TE press lever HP sensor lag error
When the trailing edge press lever was released, the TE press lever HP sensor did
not go OFF, even though the TE press lever motor operated long enough to move
the lever through and arc of 20 degrees.
 TE press lever HP sensor defective
 TE press lever motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the TE press lever motor.
 Replace the TE press lever HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
21
B
Perfect Binder: Jog fence front HP sensor late error
The front jog fence HP sensor did not go ON, even though the jog fence motor
operated long enough for 60 mm of feed.
 Jog fence front HP sensor defective
 Jog fence front motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence front motor.