Ricoh PRO C7200X - Page 342

1.SC Codes
338
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 MG lift motor defective
 MG HP sensor defective
 Connector harness loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the MG lift motor.
 Replace the MG HP sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
54
B
Perfect Binder: Main grip HP sensor lag error
 During main grip lowering, the MG HP sensor did not go OFF, even though
the main grip lift motor had operated for 1455 ms.
 MG HP sensor did not go ON when the main grip moved from down position
to up position.
 MG lift motor defective
 MG HP sensor defective
 Connector harness loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the MG lift motor.
 Replace the MG HP sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
55
B
Perfect Binder: Main grip press sensors (s) position late error
When lifting from main grip signature registration position, MG press sensors did
not go ON, even though the MG lift motor had operated for 95 ms.
 MG lift motor defective