Ricoh PRO C7200X - Page 360

1.SC Codes
356
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
34
B
Ring Binder: Pre-bind jogger clamp HP error
 When moving to the home position, the sensor could not detect the
component at the home position within the prescribed time (400 pulses). The
first occurrence triggers a jam, the second an SC code.
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (400 ms). The first occurrence triggers a
jam, the second an SC code.
 Spine clamp motor (M605) defective
 Motor overloaded
 Connector loose, broken, defective
 HP sensor (S603) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
40
B
Ring Binder: Binder unit run-out error
 When moving to the home position, the sensor could not detect the
component at the home position within the prescribed time (400 ms). The first
occurrence triggers a jam, the second an SC code.
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (400 ms). The first occurrence triggers a
jam, the second an SC code.
 Run-out press roller motor (M610) defective
 Motor overloaded
 Connector loose, broken, defective
 Run-out roller HP sensor (S614) defective
 Replace the motor
 Replace the sensor
 Replace the connector