Ricoh PRO C7200X

1.SC Codes
369
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC781-51
D
LCT2: Connection configuration error (Bridge unit connection error)
Without LCT3, the bridge unit is connected to LCT2.
 The bridge unit is connected to LCT2 in double LCT configuration.
 The interface harness on the LCT3 disconnected
 Power cord of the LCT3 disconnected
 PSU on the LCT3 defective
 Remove the bridge unit from the LCT2.
 Reconnect the interface harness connector on the LCT3.
 Plug the power cord of the LCT3.
 Replace the PSU on the LCT3.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC781-52
D
LCT2: Connection configuration error (Multi bypass tray connection error)
The multi bypass tray is connected to LCT2.
The multi bypass tray is connected to LCT2.
Remove the multi bypass tray from the LCT2.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC782-
03
B
LCT3: Protection device break error
The fuse blown signal “H (error)” of the fuse on the PSU/PCB in the LCT3 is
detected.
 Connector on the harness between PSU and PCB on LCT3 disconnected
 Harness broken
 PSU defective
 PCB defective
 Poor grounding of the 24V line
 Reconnect the connector on the harness between PSU and PCB on LCT3.
 Replace the harness
 Replace the PSU.
 Replace the PCB
 Replace the harness/actuator
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC782-
05
B
LCT3: PSU Cooling Fan 1 error
Cooling fan alarm “H (error)” is detected while the PSU Cooling Fan 1 on the
LCT3 is ON.
 PSU Cooling Fan 1 on the LCT3 defective