2. Make sure that [Specify Cut Size] is selected.
3. Enter the position of the cut for each edge using the number keys, and then press [ ].
Press [Head Edge], and then enter the cut position for the head edge using the number keys.
Press [Tail Edge], and then enter the cut position for the tail edge using the number keys.
To change the value you entered, press [Clear] and then enter a new value.
4. Press [OK] twice.
• You can adjust the position of the fore edge cut from 6 to 50 mm (0.24 to 1.96 inches) in 0.1 mm
(0.01 inch) increments.
• You can shift the position of the head and tail edge cuts from 6 to 28 mm (0.24 to 1.10 inches) in 0.1
mm (0.01 inch) increments.
Finishing to a regular size
Specify the size of the finished bound booklets and cut three edges to a regular size.
Book block paper and cover sheet compatibility
If you specify finishing to a regular size, you can select one of the following sizes: A4 , B5 JIS , A5
, 8
1
/
2
× 11 , 5
1
/
2
× 8
1
/
2
We recommend that you use the cover sheet size with the book block paper sizes as shown in the
following table.
Required finished size Book block Cover
A4 225 × 320 mm
*1
226 × 310 mm
*1
13 × 19.2
*1
13 × 19
*1
13 × 18
320 × 450 mm
*1
B5 JIS A4 A3
2. Basic Copying
114
To Next Page
Loading...
