Ricoma Quick Start Guide6
Leveling your embroidery machine is essential,
as this step will ensure your machine is secured
into place. Skipping this step may result in
injury, loss of registration of your design and
other issues.
Before leveling your machine, make sure the
four level pegs are attached to the stand legs.
See Figure 1.
To level your machine, take all four level
pegs on your machine stand and rotate them
clockwise by hand until they reach the oor.
Once the pegs have reached the oor, rotate
each nut clockwise using the provided black
wrench. Do NOT skip this important step,
as this will ensure the pegs are xed to the
ground.
Once you have tightened all four pegs, the
wheels on the machine will lift, immobilizing
it. Last, conrm the machine is secure and is
no longer able to move. Refer to the leveler
on the bottom right and left of the machine to
conrm that the machine has been properly
leveled. If the bubble is in the center of the
lines, then you have correctly completed this
step. See Figure 2.
Figure 1
Figure 2
GETTING STARTED: MACHINE OVERVIEW
Leveling the machine
To Next Page
Loading...
