Ricoma Quick Start Guide
7
The CHT2 runs on 220 volts. If you are in a country with a 220-
volt output, you can plug the machine directly into an outlet to
power it on.
If you’re in the U.S. or a country with a 110-volt electrical output,
you will need to use the transformer included with your machine
to convert the electrical output from 110 volts to 220 volts in
order to operate the machine properly.
If you’re in a country with a 110-volt output, follow these steps to
correctly turn on your machine.
1. Connect the plug on the machine’s box to the transformer.
2. Plug the transformer into an electrical outlet.
3. Turn on the transformer. See Figure 3.
4. Flip the orange switch on the machine’s box. See Figure
4.
Note: When the machine is on, the switch should be facing the back of the machine as seen in Figure 4.
Your CHT2 comes with security locks in between the machine
heads to prevent any damages during shipping. See Figure 5.
Before operating your machine, be sure to remove the locks.
Keep these locks handy in case you plan on moving your
machine to a new location in the future.
To locate the security lock, slide off the magnetic metal cover
between the heads. See Figure 6.
To remove the security lock, loosen its screws using a 4 mm
Allen wrench. You will nd a set of Allen wrenches in your toolkit.
Once the security lock is removed, return the metal cover to its
original position.
Figure 3
Figure 4
Figure 5
Figure 6
Turning on the machine – Power cord connection
Security lock
To Next Page
Loading...
