20151763
64
Appendix - Accessories
Output power regulator kit for modulating operation
With the modulating operation, the burner continually adapts the
power to the heat request, ensuring a high level of stability for the
parameter controlled: temperature or pressure.
Two components should be ordered:
– the output power regulator to be installed on the burner;
– the probe to install on the heat generator.
Software diagnostics kit
A special kit is available that, by an optical link to a PC, shows the
burner life together with operating hours, type and number of
lockouts, number of motor rpm's and safety parameters.
To view diagnostics, proceed as follows:
connect the kit (supplied separately) to the appropriate
socket on the control box. Reading of the information begins
when the software programme included in the kit starts.
A Appendix - Accessories
Parameter to be checked Probe Output regulator
Adjustment field Type Code Type Code
Temperature - 100...+ 500°C PT 100 3010110
RWF50.2 20095185
Pressure
0 ÷ 2,5 bar
0 ÷ 16 bar
0 ÷ 25 bar
Output probe
4 ÷ 20 mA
3010213
3010214
3090873
The installer is responsible for the addition of any
safety device not foreseen in this manual.
Burner Code
RX 500S/PV on demand
To Next Page
Loading...
