To Next PageTo Next Page
Need help?Do you have a question about the Riello RG4F and is the answer not in the manual?
Lists essential components like flange, screws, nuts, and plugs for burner assembly and connection.
Provides key specifications such as thermal power, fuel type, electrical requirements, motor, and pump details.
Details optional kits like Extended Head, Spacer, Control Box, and Remote Reset for enhanced functionality.
Presents detailed physical measurements and diagrams of the burner for installation planning.
Explains how firing rate is determined and includes a graph illustrating performance curves based on standards.
Guides on securing the burner to the heat generator, including flange and gasket installation.
Illustrates and specifies the permitted orientations for safe and efficient burner operation.
Describes how to connect oil supply pipes, allowing entry from either side of the burner.
Covers pump operation, pipe configurations (one/two pipe), and pressure regulation for fuel delivery.
Outlines the electrical connections, wiring standards, safety precautions, and testing procedures.
Details the process of tuning combustion by adjusting nozzle, pump pressure, head setting, and air damper.
Lists suitable nozzles and provides step-by-step instructions for replacing the burner nozzle.
Offers guidance and visual aids for correctly positioning the ignition electrodes.
Explains how to adjust the pump's delivery pressure and notes its factory setting.
Describes how to adjust the combustion head based on the burner's output and delivery rate.
Provides instructions for adjusting the air damper to control airflow for optimal combustion.
Illustrates the normal burner start-up sequence and common fault scenarios.
General
