Rigol DG1022

DG1000 Command System RIGOL
Programming Guide for DG1000
2-7
Syntax APPLy:RAMP:CH2 [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a ramp wave with specific frequency, amplitude and DC
offset via CH2. This command would overwrite the current symmetry
setting and select 50% automatically.
Explanations  If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:RAMP:CH2 1000,5.0,0.5
12. APPLy:PULSe:CH2
Syntax APPLy:PULSe:CH2 [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a pulse wave with specific frequency, amplitude and DC
offset via CH2.
Explanations  If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:PULS:CH2 1000,5.0,0.5
13. APPLy:NOISe:CH2
Syntax APPLy:NOISe:CH2[<frequency|DEFault>[,<amplitude>[,<offset>]]]
Function Generate a Gaussian noise with specific amplitude and DC offset via
CH2.
Explanations  Although the frequency parameter makes no impression on this
command, a value or “DEFault” must be specified. (noise
function has a 5MHz bandwidth)
 If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:NOIS:CH2 DEF, 5.0, 0.5
14. APPLy:DC:CH2
Syntax APPLy:DC:CH2[<frequency|DEFault>[,<amplitude>|DEFault>[,<
offset>]]]
Function Generate a DC signal with electrical level specified by <offset> via