Rigol DG1022

RIGOL DG1000 Command System
Programming Guide for DG1000
2-48
BURSt
BURSt commands are used for setting the generator to output waveforms (called
burst) with specified cycles. DG1000 can generate burst using sine, square, ramp,
pulse or arbitrary waveform and output it from CH1.
DG1000 supports following BURSt commands:
1. BURSt:MODE
2. BURSt:MODE?
3. BURSt:NCYCles
4. BURSt:NCYCles?
5. BURSt:INTernal:PERiod
6. BURSt:INTernal:PERiod?
7. BURSt:PHASe
8. BURSt:PHASe?
9. BURSt:STATe
10. BURSt:STATe?
11. BURSt:GATE:POLarity
12. BURSt:GATE:POLarity?