Rigol DG1022

DG1000 Command System RIGOL
Programming Guide for DG1000
2-3
APPLy
APPLy commands are used to quickly set the output waveforms of DG1000 and
provide the most straightforward method to program the generator over remote
interface.
DG1000 supports following APPLy commands:
1. APPLy:SINusoid
2. APPLy:SQUare
3. APPLy:RAMP
4. APPLy:PULSe
5. APPLy:NOISe
6. APPLy:DC
7. APPLy:USER
8. APPLy?
9. APPLy:SINusoid:CH2
10. APPLy:SQUare:CH2
11. APPLy:RAMP:CH2
12. APPLy:PULSe:CH2
13. APPLy:NOISe:CH2
14. APPLy:DC:CH2
15. APPLy:USER:CH2
16. APPLy:CH2?