Rigol DG1022

DG1000 Command System RIGOL
Programming Guide for DG1000
2-45
TRIGger
TRIGger commands are only available in Sweep and Burst mode. As only CH1
supports sweep and burst modes, TRIGger commands are only applicable to CH1.
DG1000 supports following TRIGger commands:
1. TRIGger:SOURce
2. TRIGger:SOURce?
3. TRIGger:SLOPe
4. TRIGger:SLOPe?
5. TRIGger:DELay
6. TRIGger:DELay?