DG1000 Command System RIGOL
Programming Guide for DG1000
SWEep
In frequency sweep mode, the generator “steps” from the start frequency to the stop
frequency at the specified sweep rate. You can sweep up or down in frequency with
either linear or logarithmic spacing.
In addition, you can configure the generator to output a single sweep (sweep from
start frequency to stop frequency) by applying an external or manual trigger. The
generator can produce a frequency sweep for sine, square, ramp or arbitrary
waveforms (pulse, noise, and DC are not allowed) from CH1.
DG1000 supports following SWEep commands:
1. SWEep:SPACing
2. SWEep:SPACing?
3. SWEep:TIME
4. SWEep:TIME?
5. SWEep:STATe
6. SWEep:STATe?
To Next Page
Loading...
