Rigol DG1022

RIGOL DG1000 Command System
Programming Guide for DG1000
2-24
OUTPut
OUTPut commands are used for setting the output parameters, such as: the output
switch, the output loads, the polarity of the waveform, the sync output signal and the
trigger output of CH1.
DG1000 supports following OUTPut commands:
1. OUTPut
2. OUTPut?
3. OUTPut:LOAD
4. OUTPut:LOAD?
5. OUTPut:POLarity
6. OUTPut:POLarity?
7. OUTPut:SYNC
8. OUTPut:SYNC?
9. OUTPut:TRIGger:SLOPe
10. OUTPut:TRIGger:SLOPe?
11. OUTPut:TRIGger
12. OUTPut:TRIGger?
13. OUTPut:CH2
14. OUTPut:CH2?
15. OUTPut:LOAD:CH2
16. OUTPut:LOAD:CH2?
17. OUTPut:POLarity:CH2
18. OUTPut:POLarity:CH2?