RIGOL DG1000 Command System
Programming Guide for DG1000
PULSe
PULSe commands are used for configuring the parameters of pulse waves from dual
channels, such as: period, pulse width, duty cycle and others. Following figure is going
to help you comprehend the parameters about pulse wave.
DG1000 supports following PULSe commands:
1. PULSe:PERiod
2. PULSe:PERiod?
3. PULSe:WIDTh
4. PULSe:WIDTh?
5. PULSe:DCYCle
6. PULSe:DCYCle?
7. PULSe:PERiod:CH2
8. PULSe:PERiod:CH2?
9. PULSe:WIDTh:CH2
10. PULSe:WIDTh:CH2?
11. PULSe:DCYC:CH2
12. PULSe:DCYC:CH2?
90% 90%
50% 50%
10% 10%
Pulse Width
Period
Rise Time
Fall Time
To Next Page
Loading...
