RIGOL DG1000 Command System
Programming Guide for DG1000
DATA
DATA commands are used for editing or saving arbitrary waves and outputing those
waves via CH1. You can store ten user-defined waveforms at most in non-volatile
memory in addition to one in volatile memory. Each waveform can contain 1 to
524,288 data points.
DG1000 supports following DATA commands:
1. DATA
2. DATA:DAC
3. DATA:COPY
4. DATA:DELete
5. DATA:CATalog?
6. DATA:RENAME
7. DATA:NVOLatile:CATalog?
8. DATA:NVOLatile:FREE?
9. DATA:ATTRibute:POINts?
10. DATA:LOAD
To Next Page
Loading...
