DG1000 Command System RIGOL
Programming Guide for DG1000
FREQuency
FREQuency commands are used for setting the frequencies of output functions of
dual channels; the start/stop frequency, the center/span frequency in sweep mode,
the carrier frequency in modulation. Sweep and modulation are only valid for CH1.
DG1000 supports following FREQuency commands:
1. FREQuency
2. FREQuency?
3. FREQuency:CH2
4. FREQuency:CH2?
5. FREQuency:STARt
6. FREQuency:STARt?
7. FREQuency:STOP
8. FREQuency:STOP?
9. FREQuency:CENTer
10. FREQuency:CENTer?
11. FREQuency:SPAN
12. FREQuency:SPAN?
To Next Page
Loading...
