Rigol DG1022

RIGOL DG1000 Command System
Programming Guide for DG1000
2-4
Detailed information of each command:
1. APPLy:SINusoid
Syntax APPLy:SINusoid [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a sine wave with specific frequency, amplitude and DC
offset via CH1.
Explanations  If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:SIN 1000,5.0,-1.5
2. APPLy:SQUare
Syntax APPLy:SQUare [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a square wave with specific
frequency, amplitude and DC
offset via CH1. This command would overwrite the current duty cycle
setting and select 50% automatically.
Explanations  If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:SQU 1000,5.0,-1.5
3. APPLy:RAMP
Syntax APPLy:RAMP [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a ramp wave with specific
frequency, amplitude and DC
offset via CH1. This command would overwrite the current symmetry
setting and select 50% automatically.
Explanations  If the parameters you set are less than three, the sequence
would be: <frequency>, <amplitude>, <offset>.
 The default units of <frequency>, <amplitude> and <offset>
are Hz, Vpp and V
DC
respectively.
Example APPL:RAMP 1000,5.0,-1.5
4. APPLy:PULSe
Syntax APPLy:PULSe [<frequency>[,<amplitude>[,<offset>]]]
Function Generate a pulse wave with specific
frequency, amplitude and DC