Statistics
Click or tap the Statistic on/off switch to enable or disable the statistical result
display. You can also click or tap at the lower-right of the measurement item in
the "Result" sidebar to expand the label to display all the statistical items. Click or tap
to collapse the label. The figure below shows the displayed results after the
Statistic of period measurement is enabled.
• Click or tap any measurement item in the "Result" sidebar at the right side of the
screen and a window is displayed. Click or tap Reset Stat. to clear the history
statistics data and makes statistics again. You can also click or tap Reset Stat. in
the measurement setting menu.
• Click or tap the input field of
Count and use the pop-up numeric keypad to set
the count value. You can also use the corresponding multipurpose knob to set
the value. Its range is from 2 to 100000. Its default value is 1000.
10.2.4 Remove the Measurement Results
This oscilloscope allows you to delete the measurement results of the parameters.
• In Measure setting menu, click or tap Remove to delete the currently selected
measurement item that you've added; click or tap Remove All to delete all the
displayed measurement items.
• Click or tap any measurement item in the "Result" sidebar at the right side of the
screen and a window is displayed. Click or tap
Remove to delete the currently
Measurements
DHO900 User Guide
146
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
Need help?
General
