Rigol DS8000-R Series

RIGOL Chapter 19 System Utility Function Setting
19-18 DS8000-R User Guide
System Time
The system time is displayed at the lower-right side of the screen in "hh:mm
(hour:minute)" format. When you save the waveform, the output file will contain the
time information.
Click Utility → More → More → Time to open the time setting menu.
1. Set the System Time
(1) Click Show Time to open or close the system time interface.
(2) Set "year": Click Year to set it. Use the pop-up numeric keypad to input the
numeric value or scroll with the mouse to set it.
(3) Set "month": Click Month to set it. Use the pop-up numeric keypad to input
the numeric value or scroll with the mouse to set it.
(4) Set "day": Click Day to set it. Use the pop-up numeric keypad to input the
numeric value or scroll with the mouse to set it.
(5) Set "Hour": Click Hour to set it. Use the pop-up numeric keypad to input
the numeric value or scroll with the mouse to set it.
(6) Set "Minute": Click Minute to set it. Use the pop-up numeric keypad to
input the numeric value or scroll with the mouse to set it.
The setting range of each item of the system time conforms to the convention.
⚫ Year: 2017 to 2099
⚫ Month: 01 to 12
⚫ Date: 01 to 31 (28, 29, or 30)
⚫ Hour: 00 to 23
⚫ Minute: 00 to 59
⚫ Second: 00 to 59
2. Apply the Currently Set System Time
Click Apply to validate the current settings. The time at the lower-right side of
the screen will be updated.
Default Option
Used to determine whether the impedance is modified while configuring the
oscilloscope to restore its default settings. To restore its default settings, two
methods are available.
⚫ Click the function navigation icon to open the function navigation. Click Storage
→ More → Default.
⚫ Click the Default key at the right section of the operation interface in Web
Control page.
Click Utility → More → More → Default Option, then enter the default option