Rigol DS8000-R Series

Chapter 2 To Set the Vertical System RIGOL
DS8000-R User Guide 2-1
Chapter 2 To Set the Vertical System
DS8000-R series provides four analog input channels (CH1-CH4), and each channel
is equipped with an independent vertical control system. The setting methods for the
vertical systems of the four channels are the same. This chapter takes CH1 as an
example to introduce the setting method for the vertical system. For this oscilloscope,
only CH1 is enabled by default.
Contents in this chapter:
◼ To Enable or Disable the Analog Channel
◼ To Adjust the Vertical Scale
◼ Vertical Expansion
◼ To Adjust the Vertical Offset
◼ Channel Coupling
◼ Bandwidth Limit
◼ Probe Ratio
◼ Input Impedance
◼ Waveform Invert
◼ To Set the Probe
◼ Amplitude Unit
◼ Channel Delay
◼ Offset Cal
◼ Channel Label