RIGOL Chapter 2 Front Panel Operations
2-70 M300 User’s Guide
Channel Status Table
Press
at the front panel again to enter the channel status table interface as
shown in Figure 2-34. In this interface, you can judge the channel status.
Yellow: channels not added to the scan list is displayed in yellow
Green: channels added to the scan list is displayed in green
Red: during a scan, an alarm is generated, the corresponding channel is
displayed in red
Note: This status table displays the channel status in real time. For example, the
channel is displayed in red after an alarm is generated. If the next measurement
value is judged as PASS, the channel will be displayed in green again.
Figure 2-33 Channel Status Table
Measurement Curve
Press
at the front panel again and the instrument enters an interface with a
blank coordinate. This interface can display the measurement curves of the specified
channels.
1 Switch
Press Switch to switch the cursor to select the channel number or the curve. By
default, the channel number is selected. At this point, you can delete the
channel selected or select other channel number by using the left/right direction
keys. Press Switch to switch the cursor to select the curve and use the left/right
direction keys to view the curve outside of the range of the horizontal axis.
To Next Page
Loading...