Rigol M300 Series - Module Copy

RIGOL Chapter 2 Front Panel Operations
2-40 M300 User’s Guide
Module Copy
Module copy can copy the configuration of a module (source module) to another
module (target module) of the same model. After that, the configuration of each
channel of the source module is copied to the target module automatically.
Press Module to enter the module copy interface.
 Switch: switch the cursor between the “Source Module” and “Target Module”
areas.
 OK: copy the configuration of the source module selected to the target module
selected.
 Return: return to the upper-level menu.
Figure 2-9 Module Copy
Steps of Module Copy:
1 After entering the module copy interface, the “Source Module” area is selected
by default. Use the up/down direction keys to select the desired source module.
2 Press Switch to move the cursor to the “Target Module” area and use the
up/down direction keys to select the desired target module.
3 Press OK to execute module copy.
Note: The source module and target module selected must be of the same model
and it is forbidden to copy the configuration of a module to itself.