Rigol M300 Series - Extended Copy

Chapter 2 Front Panel Operations RIGOL
M300 User’s Guide
2-43
Extended Copy
Extended copy allows copying the configuration of a channel (source channel) of a
module to all the channels (which type is the same to that of the source channel) of
the target module. After that, the following settings will be copied to the target
module automatically.
1 Measurement Configuration: include measurement function, range, etc.
2 Scaling Setting: on/off status of the scaling function and scaling coefficients;
3 Alarm Setting: on/off status of the alarm function, alarm channel number and
alarm limits;
4 Advanced Configuration: include integration time, AC filter, etc.
Press Extended to enter the extended copy interface.
 Switch: switch the cursor between the “Source Channel” area and “Target
Module” area.
 OK: copy the configuration of the source channel selected to the target module
selected.
 Return: return to the upper-level menu.
Figure 2-11 Extended Copy
Steps of Extended Copy
1 After entering the extended copy interface, the “Source Channel” area is
selected by default. Use the direction keys to select the desired source channel.
2 Press Switch to move the cursor to the “Target Module” area and use the
up/down direction keys to select the desired target module.
3 Press OK to execute extended copy.
Note:
For extended copy, only copies among the same type of modules are allowed. This
function makes it easy to configure several channels for the same measurement.