EasyManua.ls Logo

Rigol M300 Series - Rear Panel

Rigol M300 Series
190 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RIGOL Chapter 1 Quick Guide
1-8 M300 User’s Guide
Rear Panel
1 2 3 4 5
Figure 1-4 Rear Panel of M300
1 Slots
The M300 provides 5 slots for 5 modules. The 5 slots from left to right in the
figure above correspond to the 5 module indicators at the front panel
respectively. When a module is inserted in the slot, the corresponding module
indicator at the front panel goes on. Figure 1-4 is the schematic diagram of the
rear panel without the modules inserted. For information of each module, refer
toPlug-in Module Overview.
CAUTION
Only one DMM module is permitted for one mainframe.
2 USB Device
Via this interface, M300 can communicate with the PC as a slave device and you
can control it remotely via the PC.
3 LAN
M300 conforms to the LXI Core 2011 Device standard. The instrument can be
connected to the network via this interface and you can control the instrument
remotely via a PC in the same network.
4 Analog Bus Interface (Female)
M300 provides two internal 2-wire analog buses for signal routing as well as an
10
6
7
8
9

Table of Contents