Rigol M300 Series - Measurement Parameter Configuration

RIGOL Chapter 2 Front Panel Operations
2-22 M300 User’s Guide
Measurement Parameter Configuration
This section introduces the measurement parameters (such as the range and
integration time) that can be configured in the first and fourth steps of the
configuration guide. The parameters available for configuration vary for each
measurement function as shown in the table below.
Table 2-1 Measurement Parameter
Function
Parameter
DCV
Range, Integration Time, Input Impedance, Auto Zero (AZ), Channel
Delay
ACV
Range, AC Filter, Channel Delay
DCI
Range, Integration Time, Auto Zero (AZ), Channel Delay
ACI
Range, AC Filter, Channel Delay
2WR
4WR
Range, Integration Time, Offset Compensation, Auto Zero (AZ),
Channel Delay
FREQ
PERIOD
Range, AC Filter, Gate Time, Channel Delay
TEMP Type
TC
Model, Unit, Precision, Integration Time, T/C Check,
Reference Source, Auto Zero (AZ), Channel Delay
THER
Model, Unit, Precision, Integration Time, Auto Zero
(AZ), Channel Delay
RTD
RTD 4W
R0, ALPHA, Unit, Precision, Integration Time, Offset
Compensation, Auto Zero (AZ), Channel Delay
SENSOR Type
DCV
Unit, Scaling, Integration Time, Input Impedance,
Auto Zero (AZ), Channel Delay
DCI
Unit, Scaling, Integration Time, Auto Zero (AZ),
Channel Delay
2WR
4WR
Unit, Scaling, Integration Time, Offset
Compensation, Auto Zero (AZ), Channel Delay
FREQ
Unit, Scaling, AC Filter, Channel Delay
Note: When the measurement function of the current channel is changed, all the
parameters will be restored to their defaults.