Chapter 4 Remote Control RIGOL
M300 User’s Guide
Using RS232 Interface:
Convert the [RS-232/Alarms/Ext Trig] interface at the rear panel to two
9-pin interfaces using the Mixed Interface Convert Cable (accessory).
Wherein, one is a 9-pin male interface used as a standard RS232 interface.
Connect this interface with the computer using RS232 cable and set proper
parameters according to “To Set RS232 Parameters
”.
Using LAN Interface:
Connect M300 to the LAN of the computer and set proper parameters
according to “To Set LAN Parameters”.
3 Programming
Then, you can select a familiar software developing tool (such as LabVIEW,
Matlab, Visual C++, etc.) for programming. For detailed information about SCPI
commands and programming method of M300, refer to M300 Programming
Guide.
To Next Page
Loading...