Chapter 1 Quick Guide RIGOL
M300 User’s Guide
4 current channels are used in combination with the DMM module to measure DC
current or AC current. All channels in the scan list are break-before-make. In any
case, you cannot close multiple channels on this module.
This module can be connected with MC3065 (DMM Module, if MC3065 is currently
inserted).
MC3416 (16-Channel Actuator)：
The MC3416 can connect signals to the device under test or enable external devices.
Any of the 16 channels can switch to Normally-Open (NO) and Normally-Closed (NC)
states.
MC3534 (Multifunction Module)：
This module provides 3 kinds of functions with 4 channels for each function. This
module can be used to check status or control external devices (such as solenoid,
power relays and microwave switches). You can also read digital inputs and the
totalizer count during a scan.
Four 8–bit digital input/output (DIO) ports
4 totalizer (TOT) input terminals (the first two channels are 10 MHz TOT and the
other two channels are 100 kHz TOT) with 1 Vpp sensitivity
4 analog output terminals, ±12 V calibrated voltage
MC3648 (4×8 Matrix Switch)：
The MC3648 is used to connect multiple devices to multiple points on the device
under test. You can connect the rows and columns of multiple matrix switches to
form relatively larger matrix (such as 8×8 and 4×16, the number of crosspoints
cannot exceed 160).
32 two-wire cross points which can connect any combination of inputs and outputs at
the same time.
To Next Page
Loading...